纺织学报 ›› 2018, Vol. 39 ›› Issue (03): 14-18.doi: 10.13475/j.fzxb.20170606705

• 纤维材料 • 上一篇    下一篇

碳纳米线的拉伸应变传感特性

  

  • 收稿日期:2017-06-23 修回日期:2017-09-29 出版日期:2018-03-15 发布日期:2018-03-09

Tensile strain sensing characteristics of carbon nanoyarns

  • Received:2017-06-23 Revised:2017-09-29 Online:2018-03-15 Published:2018-03-09

摘要:

为开发用于三维编织复合材料原位结构健康监测的碳纳米线传感器,建立了碳纳米线应变传感实验系统,通过纵向拉伸实验,分析了碳纳米线的机械性能(应力和应变)和电性能(初始电阻和应变灵敏系数)之间的关系,并对性能参数进行了Weibull 统计分析,系统研究了碳纳米线的应变传感特性。结果表明:纵向拉伸负载期间,碳纳米线相对电阻变化与应变呈现良好的线性关系;碳纳米线具有与传统应变监测相当的应变灵敏系数,适合用于检测破坏极限应变远小于碳纳米线应变(碳纳米线的破坏应变均值10%,最小值为2.5%)的复合材料的损伤,是复合材料结构健康监测传感器的良好候选材料。

关键词: 结构健康监测, 碳纳米线传感器, 三维编织复合材料, 线性相关, 应变灵敏系数

Abstract:

In order to develop carbon nanoyarn sensors used in three-dimensional braided composites in-situ structural health monitoring, a carbon nanoyarn strain sensing experiment system was established. By the longitudinal tensile experiment, the correlation between the mechanical properties (stress and strain) and the electrical properties (initial resistance and strain sensitivity coefficient) of carbon nanoyarns was investigated, and Weibull statistical analysis on performance parameters was conducted. The strain sensing characteristics of carbon nanoyarns were systematically studied.The results show that the relative resistance variation and the strain of carbon nanoyarns under longitudinal tensile load have a good linear correlation. Besides, carbon nanoyarns provide a strain sensitivity coefficient equivalent to conventional strain monitoring, which is very suitable for monitoring composites whose failure strain limit is far less than the strain of carbon nanoyarns(carbon nanoyarns damage strain mean of 10% and the minimum value of 2.5%). Therefore, carbon nanoyarns become a good candidate material of sensors for composite structural health monitoring.

Key words: structural health monitoring, carbon nanoyarn sensor, three-dimensional braided composite, linear correlation, strain sensitivity coefficiency

[1] 贾树生 杨连贺 白会肖 万振凯 . 嵌入三维编织复合材料的碳纳米线应变传感特性[J]. 纺织学报, 2018, 39(01): 11-18.
[2] 万振凯 张志刚 贾敏瑞 包玮琛 董卿霞. 基于碳纳米线传感器的三维六向编织复合材料内部损伤定位[J]. 纺织学报, 2017, 38(08): 68-74.
[3] 万振凯 贡丽英 万莉. 基于损伤指数的三维编织复合材料结构损伤评估[J]. 纺织学报, 2017, 38(05): 69-74.
[4] 万莉 郭建民 马永军. 三维编织复合材料弯曲承载下嵌入碳纳米线的特性分析[J]. 纺织学报, 2016, 37(01): 57-63.
[5] 万振凯 贾敏瑞. 基于磁通图像的平板三维编织复合材料试件内部缺陷检测[J]. 纺织学报, 2015, 36(08): 49-55.
[6] 李志刚. 基于超快速液相色谱/串联质谱联用法的生态纺织品中5种黄色分散染料测定[J]. 纺织学报, 2013, 34(11): 113-0.
[7] 练军;顾伯洪. 三维编织复合材料动态冲击性能的数值模拟[J]. 纺织学报, 2011, 32(1): 41-45.
[8] 万振凯;王占刚. 基于神经网络的复合材料缺陷超声波检测研究[J]. 纺织学报, 2010, 31(2): 54-59.
[9] 万振凯;王占刚. 基于SQUID的复合材料承载电气特性[J]. 纺织学报, 2010, 31(1): 58-63.
[10] 唐予远.;陈彩虹;孙宝忠. 四步法三维编织复合材料的动态拉伸性能[J]. 纺织学报, 2008, 29(2): 46-49.
[11] 万振凯;李静东. 三维编织复合材料压缩损伤声发射特性分析[J]. 纺织学报, 2006, 27(2): 20-24.
[12] 吴晓青;李嘉禄;王晓生;崔振兴;宋春华;周清. 三维编织复合材料RTM工艺的模具设计[J]. 纺织学报, 2003, 24(01): 55-56.
[13] 周文龙;孙铠. 比色法测定羊毛蛋白酶减量的研究[J]. 纺织学报, 2001, 22(04): 52-53.
Viewed
Full text


Abstract

Cited

  Shared   
  Discussed   
No Suggested Reading articles found!