纺织学报 ›› 2018, Vol. 39 ›› Issue (05): 20-24.doi: 10.13475/j.fzxb.20170604805

• 纤维材料 • 上一篇    下一篇

再生丝素蛋白溶液脱盐新工艺及其应用

  

  • 收稿日期:2017-06-19 修回日期:2018-01-29 出版日期:2018-05-15 发布日期:2018-05-10

Novel desalination process and application of regenerated silk fibroin solution

  • Received:2017-06-19 Revised:2018-01-29 Online:2018-05-15 Published:2018-05-10

摘要:

为提高丝素蛋白溶液的脱盐效率,降低脱盐能耗,采用扩散渗析-电渗析集成膜分离技术对丝素蛋白溶液进行脱盐,并初步探索所得溶液的应用。研究了丝素蛋白溶液浓度质量分数和扩散渗析预脱盐率对脱盐效率和能耗的影响,同时将所得丝素蛋白溶液加入无水乙醇制备不溶性丝素蛋白粉,测定了产品氨基酸的组成并利用扫描电子显微镜对丝素蛋白粉进行表征。结果表明,最佳的脱盐技术参数为丝素蛋白溶液浓度为5%、扩散渗析预脱盐率为40%,在此工艺条件下脱盐时间缩短至9 h,能耗(动力能耗除外)为3.81×10-2 kw?h/L;产品中丝氨酸和甘氨酸含量接近50%,丝素蛋白粉末粒径较小且分布均匀。

关键词: 丝素蛋白, 脱盐工艺, 扩散渗析, 电渗析, 丝素蛋白粉

Abstract:

In order to improve the efficiency and reduce the energy consumption in the desalination of fibroin solution, the diffusion dialysis and electrodialysis membrane separation technique was applied to the desalination process, and the application properties of the silk fibroin solution were preliminarily explored. Factors affecting the desalting efficiency and energy, such as the concentration of silk fibroin and the pre-desalination rate were investigated. Moreover the insoluble silk fibroin powder was prepared by adding anhydrous ethanol to the silk fibroin solution, the amino acid composition of the product was determined and the silk fibroin powder was characterized by scanning electron microscopy. The results show that the optimal parameters for desalting is 5% of the concentration of silk fibroin and  40% of the pre-desalination rate. Under this condition, the desalination time is shortened to 9 h and the energy consumption (except dynamic power consumption) is 3.81x10-2 kw?h/L;the total content of serine and glycine in the product is close to 50%, and scanning electron microscopic results show that the particle size of the powder is smaller and the distribution is uniform.

Key words: silk fibroin, desalination process, diffusion dialysis, electrodialysis, silk fibroin powder

[1] 姚勇波 颜志勇 李喆 易洪雷 张玉梅 王华平. 牵伸倍率分配对纤维素/丝素蛋白共混纤维形态结构的影响[J]. 纺织学报, 2018, 39(06): 13-18.
[2] 王宗乾 杨海伟 王邓峰. 脱胶对蚕丝纤维的溶解及丝素蛋白性能的影响[J]. 纺织学报, 2018, 39(04): 69-76.
[3] 吴惠英. 脱胶工艺对蚕丝溶解及再生丝素蛋白纤维性能的影响[J]. 纺织学报, 2017, 38(08): 75-80.
[4] 王利君 熊杰 骆菁菁 赵兴艳 赵新飞. 聚乳酸-聚己内酯/丝素蛋白三元复合纳米纤维膜支架的结构与性能[J]. 纺织学报, 2017, 38(05): 8-13.
[5] 周步光 张宇慧 王平 王强 范雪荣. 丝素/丙烯酰胺/丙烯酸吸水复合材料的紫外光辐照法制备[J]. 纺织学报, 2017, 38(05): 25-30.
[6] 许云辉 李继丰 王云霞 张飞 杜兆芳. 丝素酰胺改性棉织物的结构及性能[J]. 纺织学报, 2017, 38(02): 134-140.
[7] 付正婷 杜兆芳 王健 董丹丹. 丝素蛋白改性聚丙烯腈纤维的涂覆法制备[J]. 纺织学报, 2016, 37(01): 6-10.
[8] 周莹 唐耿铁 王平 王强 范雪荣. 酪氨酸酶酶促乳铁蛋白在丝素表面的接枝[J]. 纺织学报, 2014, 35(1): 87-0.
[9] 贾长兰. 纳米TiO2改性丝素膜中的纳米颗粒粒径分析[J]. 纺织学报, 2013, 34(11): 24-0.
[10] 吴斌伟;朱海霖;张乐伟;冯新星;陈建勇. 静电纺丝素/聚丁二酸丁二醇血管材料的结构与性能[J]. 纺织学报, 2011, 32(4): 1-6.
[11] 周旸;郑海玲;胡智文;赵 丰. 丝素蛋白/戊二醛加固处理对对糟朽丝织品性能的影响[J]. 纺织学报, 2010, 31(8): 78-81.
[12] 周伟涛;何建新;杜姗;崔世忠;高卫东. 丝素蛋白/醋酸纤维素共混纤维毡的制备与表征[J]. 纺织学报, 2010, 31(11): 16-19.
[13] 王曙东;张幼珠;王红卫;尹桂波;董智慧;符伟国;施德兵. 静电纺PLA/丝素-明胶管状支架的结构与性能[J]. 纺织学报, 2009, 30(06): 6-9.
[14] 陈忠敏;郝雪菲;吴大洋;饶佳家;邵飞. 再生蚕丝丝素蛋白纳米颗粒的制备及抗菌性[J]. 纺织学报, 2008, 29(7): 17-20.
[15] 姚理荣;林红;陈宇岳;王浩. 丝素蛋白氧化棉纤维的共价结构分析[J]. 纺织学报, 2008, 29(2): 11-14.
Viewed
Full text


Abstract

Cited

  Shared   
  Discussed   
No Suggested Reading articles found!