三维机织正交结构复合材料的参数化设计

纺织学报 ›› 2010, Vol. 31 ›› Issue (12): 59-63.

三维机织正交结构复合材料的参数化设计

冯兆行；田伟；马雷雷；刘鹏；祝成炎

浙江理工大学先进纺织材料与制备技术教育部重点实验室

收稿日期:2010-01-15 修回日期:2010-07-28 出版日期:2010-12-15 发布日期:2010-12-15
通讯作者: 祝成炎

Parametric design of three-dimensional woven orthogonal composite material

FENG Zhaohang；TIAN Wei；MA Leilei；LIU Peng；ZHU Chengyan

Key Laboratory of Advanced Textile Materials and Manufacturing Technology, Ministry of Education, Zhejiang Sci-Tech University

Received:2010-01-15 Revised:2010-07-28 Online:2010-12-15 Published:2010-12-15

摘要/Abstract

摘要：

为给三维机织正交结构复合材料的力学模拟分析提供一种模型，通过观察3层机织正交结构复合材料预制件的细观几何结构，分析其最小重复单元中纱线间的几何位置关系，探讨细观结构中的几何参数与宏观设计参数的关系。在此基础上，利用Pro/Engineer软件对复合材料预制件进行参数化设计，建立三维机织正交结构预制件的通用几何模型。通过对比制得的三维机织复合材料的实际结构与模型结构以及纤维体积分数，验证了该模型的合理性。

Abstract:

In order to develop an available model for simulative analysis of mechanical properties of 3D woven orthogonal structure composites, the micro-geometry structure of the preform of three-layer orthogonal woven composite was observed and the geometric positional relationship between the yarns in the least repeating unit of the three-layer orthogonal woven composite was analyzed. Then the relationship between the geometrical parameters of the least repeating unit and the designing parameters was discussed. On this basis, parametric design of the preform of composite material was carried out by using Pro/Engineer software, and a common model of the 3D orthogonal structural preform was established. And then, the rationality of the model was verified by comparing the actual structure, model structure, and the fiber volume fraction.

冯兆行;田伟;马雷雷;刘鹏;祝成炎. 三维机织正交结构复合材料的参数化设计[J]. 纺织学报, 2010, 31(12): 59-63.

FENG Zhaohang;TIAN Wei;MA Leilei;LIU Peng;ZHU Chengyan. Parametric design of three-dimensional woven orthogonal composite material[J]. JOURNAL OF TEXTILE RESEARCH, 2010, 31(12): 59-63.

参考文献

Metrics

Viewed

Full text

Abstract

Cited

Shared

Discussed