纺织学报 ›› 2014, Vol. 35 ›› Issue (6): 119-0.

• 机械与器材 • 上一篇    下一篇

毛纺针梳机导条机构的MAPLE运动仿真设计及分析

王浩程,刘健   

  1. 天津工业大学工程教学实训中心
  • 收稿日期:2013-07-29 修回日期:2014-03-11 出版日期:2014-06-15 发布日期:2014-06-09
  • 通讯作者: 王浩程 E-mail:306403362@qq.com

Simulation design and analysis of sliver guide mechanism of gilling machine with MAPLE

  • Received:2013-07-29 Revised:2014-03-11 Online:2014-06-15 Published:2014-06-09
  • Contact: Hao-Cheng WANG E-mail:306403362@qq.com

摘要: 毛纺针梳机导条机构一般采用椭圆齿轮-正弦传动机构,以满足导丝器匀速往复运动的要求。该机构在进行设计和运动分析时,单独使用做图法或解析法其分析过程都十分繁琐。本文介绍了用MAPLE对毛纺针梳机导条机构进行设计和运动分析的方法。根据工作要求确定机构参数,对参数加以修正以得到理想的机构运动状态。该方法可以直观地得到机构运动的动态模拟效果,同时也可得到各个运动参数变化的图形及数值结果。可以看出,该方法对于其它各种机构的运动分析具有普遍的适用性。

关键词: 针梳机, 导条机构, 运动设计, 椭圆齿轮, 正弦机构, MAPLE

Abstract: Abstract: The ellipse gear-sine mechanism is used usually in conducting bar mechanism of wool spinning gilling machine so as to meet requirements of uniform motion of conducting bar implement. The process of the design and analysis of this mechanism is very complicated if only graphic means or math analysis is used. This paper has been described the method in which the kinematical behavior of a conducting bar mechanism is analyzed with MAPLE. According to the curve of the mechanism’s drive function, all parameters has been selected experientially. Then, optimizing these parameters so as to get a ideal movement status. The result of dynamic analogue of the mechanism is obtained visually. Simultaneously, graph and numeric which reflect the change of motion parameters can be shown.

Key words: gilling machine, sliver guide mechanism, motion design, ellipse gear, sine mechanism, MAPLE

中图分类号: 

  • TH112
[1] 王浩程.. 六连杆打纬机构的MAPLE动态设计及分析[J]. 纺织学报, 2006, 27(6): 32-35.
[2] 罗佑新. 机构综合的结式消元法及其MAPLE实现[J]. 纺织学报, 2005, 26(2): 79-81.
Viewed
Full text


Abstract

Cited

  Shared   
  Discussed   
No Suggested Reading articles found!