纺织学报 ›› 2021, Vol. 42 ›› Issue (02): 107-112.doi: 10.13475/j.fzxb.20200706106

• 纺织工程 • 上一篇    下一篇

基于ABAQUS的筒状纬编针织物拉伸力学性能模拟

孙亚博1, 李立军2,3, 马崇启1(), 吴兆南1, 秦愈1   

  1. 1.天津工业大学 纺织科学与工程学院, 天津 300387
    2.东南大学 自动化学院,江苏 南京 210096
    3.宁波慈星股份有限公司, 浙江 宁波 315336
  • 收稿日期:2020-07-22 修回日期:2020-11-02 出版日期:2021-02-15 发布日期:2021-02-23
  • 通讯作者: 马崇启
  • 作者简介:孙亚博(1996—),男,硕士生。主要研究方向为针织物性能的有限元模拟。

Simulation on tensile properties of tubular weft knitted fabrics based on ABAQUS

SUN Yabo1, LI Lijun2,3, MA Chongqi1(), WU Zhaonan1, QIN Yu1   

  1. 1. School of Textile Science and Engineering, Tiangong University, Tianjin 300387, China
    2. School of Automation, Southeast University, Nanjing, Jiangsu 210096, China
    3. Ninbo Cixing Co., Ltd., Ningbo, Zhejiang 315336, China
  • Received:2020-07-22 Revised:2020-11-02 Online:2021-02-15 Published:2021-02-23
  • Contact: MA Chongqi

摘要:

为更好地了解筒状纬编针织物抵抗拉伸变形的能力,基于对织物试样尺寸测量得到的几何结构参数,借助Rhino 3D建模软件建立了纬编针织物线圈模型和筒状纬编针织物模型;同时利用有限元分析软件ABAQUS在单位线圈和筒状织物2个方面研究了筒状纬编针织物的纵向拉伸性能;对织物拉伸过程进行有限元模拟和实验验证,并对针织物拉伸过程中纱线形变和应力分布进行探讨,将有限元仿真结果和拉伸实验结果进行对比分析。结果表明:筒状针织物纵向拉伸时,发生线圈转移和纱线伸长现象,其形变和应力变化的有限元分析结果描述准确,应力-应变数值计算结果与实验结果的差异在8%以内,证明有限元仿真的可行性。

关键词: 筒状纬编针织物, 针织物几何模型, 拉伸力学性能, 有限元仿真

Abstract:

In order to better understand the tensile deformation capability of tubular weft knitted fabrics, a three-dimensional weft knitted fabric loop model and a tubular weft knitted fabric model were established using a three-dimensional modeling software Rhino, on the basis of the measured fabric structure parameters. The tensile properties of the fabric were simulated on unit loop level and tubular fabric level using the finite element analysis software ABAQUS. Numerical simulations of fabric tensile process were studied and corresponding experiment verification was carried out. Deformation and stress distribution of yarns in the stretching process of knitted fabrics were analyzed and discussed. The results indicate that when fabrics are stretched along the length direction, the finite element analysis results of its deformation and stress change are described accurately compared to the experimental results. Moreover, the difference in stress and strain values between the simulated and the experimental results is about 8%, indicating that the numerical simulation is feasible and effective.

Key words: tubular weft knitted fabric, geometric model of knitted fabric, tensile mechanical property, finite element simulation

中图分类号: 

  • TS101.8

图1

线圈型值点 w—横向圈距;b—圈弧高度;l—圈高;c—圈柱宽度;r—线圈截面半径。"

表1

线圈型值点相对坐标"

型值点 坐标 型值点 坐标
n1 (-2a, 0, r) n6 (a+0.5c, b+l, 0)
n2 (0.5c-a, b, 0) n7 (a, b+0.5l,-r)
n3 (-a, b+0.5l, -r) n8 (a-0.5c, b, 0)
n4 (-a-0.5c, b+l, 0) n9 (2a, 0, r)
n5 (0, 2b+l, r)

图2

线圈三维模型"

图3

筒状针织物模型"

表2

纱线拉伸性能参数"

密度/
(g·cm-3)
强力/
cN
伸长
率/%
屈服应
力/MPa
弹性模
量/MPa
泊松比
0.92 579.80 7.48 19.61 1 829.36 0.20

图4

单位模型载荷设定"

图5

单位模型拉伸过程应力分布"

图6

筒状针织物拉伸后应力分布"

图7

织物应力-应变的模拟计算与实验对比"

表3

有限元模拟结果与实验结果对比"

应变/% 应力实验值/MPa 应力理论值/MPa 误差/%
5 0.085 0.088 4.01
10 0.261 0.282 7.4
15 0.774 0.798 2.1
20 1.253 1.236 1.3
25 1.830 1.985 7.8
30 2.814 2.997 6.1
35 3.827 3.694 3.6
[1] 李瑛慧, 谢春萍, 刘新金, 等. 真丝和涤纶仿真丝织物的拉伸性能有限元仿真[J]. 丝绸, 2018,55(3):27-31.
LI Yinghui, XIE Chunping, LIU Xinjin, et al. Finite element simulation of tensile mechanical properties of silk fabrics and polyester silk-like fabrics[J]. Journal of Silk, 2018,55(3):27-31.
[2] 谭磊, 胡心怡. 拉伸方向对针织物断裂强力和断裂伸长的影响[J]. 天津工业大学学报, 2001 (5):53-55.
TAN Lei, HU Xinyi. Affection of tensile direction on the break strength and stretch of knitted fabrics[J]. Journal of Tiangong University, 2001(5):53-55.
[3] 潘月, 岑洁, 游晓悦, 等. 服用织物拉伸性能的各向异性分析[J]. 浙江理工大学学报, 2015,33(11):733-737, 743.
PAN Yue, CEN Jie, YOU Xiaoyue, et al. Anisotropic analysis of fabric tensile property[J]. Journal of Zhejiang Sci-Tech University, 2015,33(11):733-737,743.
[4] WANG Z, HU H. A finite element analysis of an auxetic warp-knitted spacer fabric structure[J]. Textile Research Journal, 2014,85(4):404-415.
[5] 李瑛慧, 谢春萍, 刘新金. 三原组织织物拉伸力学性能有限元仿真[J]. 纺织学报, 2017,38(11):41-47.
LI Yinghui, XIE Chunping, LIU Xinjin. Finite element simulation on tensile mechanical properties of three-elementary weave fabric[J]. Journal of Textile Research, 2017,38(11):41-47.
[6] GHORBANI E, HASANI H, JAFARI N R. Finite element modelling the mechanical performance of pressure garments produced from elastic weft knitted fabrics[J]. Journal of The Textile Institute, 2018,110(5):724-731.
[7] 刘倩楠, 张涵, 刘新金, 等. 基于ABAQUS的三原组织机织物拉伸力学性能模拟[J]. 纺织学报, 2019,40(4):44-50.
LIU Qiannan, ZHANG Han, LIU Xinjin, et al. Simulation on tensile mechanical properties of three-elementary weave woven fabrics based on ABAQUS[J]. Journal of Textile Research, 2019,40(4):44-50.
[8] 任工昌, 崔延琳, 杨君顺. 基于Rhino_3D的工业产品造型设计[J]. 包装工程, 2008 (1):124-126.
REN Gongchang, CUI Yanlin, YANG Junshun. Shape design of industrial product based on Rhino-3D[J]. Packaging Engineering, 2008 (1):124-126.
[9] 沙莎, 蒋高明. 纬编针织物三维模拟技术的研究现状与发展趋势[J]. 纺织学报, 2016,37(11):166-172.
SHA Sha, JIANG Gaoming. Research status and development trend of 3-D simulation technology for weft knitted fabric[J]. Journal of Textile Research, 2016,37(11):166-172.
[10] 石若星, 钟智丽, 万佳. 玄武岩长丝/芳纶间隔纱织物复合板材平压性能的有限元模拟[J]. 轻纺工业与技术, 2018,47(11):15-16,31.
SHI Ruoxing, ZHONG Zhili, WAN Jia. Finite element simulation of flat compression performance of basalt filament/aramid spacer yarn fabric composite sheet[J]. Light and Textile Industry and Technology, 2018,47(11):15-16,31.
[11] 吴济宏. 针织物结构与力学性能及其对服装压的影响[D]. 上海:东华大学, 2012: 105-107.
WU Jihong. Study on structures and mechanical properties of knitted fabric and its influence on the clothing pressure[D]. Shanghai: Donghua University, 2012: 105-107.
[1] 戴宁, 彭来湖, 胡旭东, 崔英, 钟垚森, 王越峰. 纬编针织机织针自由状态下固有频率测试方法[J]. 纺织学报, 2020, 41(11): 150-155.
[2] 张祝辉, 张典堂, 钱坤, 徐阳, 陆健. 广角机织物的织造工艺及其偏轴拉伸力学性能[J]. 纺织学报, 2020, 41(08): 27-31.
[3] 刘倩楠 刘新金. 采用ABAQUS的粘胶机织物拉伸力学性能仿真[J]. 纺织学报, 2018, 39(09): 39-43.
[4] 李瑛慧 谢春萍 刘新金. 三原组织织物拉伸力学性能有限元仿真[J]. 纺织学报, 2017, 38(11): 41-47.
[5] 王占山 吕利叶 张佳丽 杨育林 张芳芳. 聚四氟乙烯/芳纶破斜纹织物衬垫拉伸性能数值仿真[J]. 纺织学报, 2016, 37(07): 71-76.
[6] 曹艳. 自卷曲复合长丝PET/PTT纺丝工艺及性能[J]. 纺织学报, 2011, 32(2): 6-10.
Viewed
Full text


Abstract

Cited

  Shared   
  Discussed   
No Suggested Reading articles found!