纺织学报 ›› 2014, Vol. 35 ›› Issue (3): 52-0.

• 染整与化学品 • 上一篇    下一篇

紫外线辐照对棉纤维结构与性能的影响

李涛,张涛,张开瑞,王潮霞   

  1. 生态纺织教育部重点实验室(江南大学)
  • 收稿日期:2013-04-07 修回日期:2013-09-02 出版日期:2014-03-15 发布日期:2014-03-11
  • 通讯作者: 王潮霞 E-mail:wchaoxia@sohu.com
  • 基金资助:

    六大人才高峰高层次人才项目;333高层次人才培养工程项目

Effect of UV irradiation on structure and properties of cotton fibers

  • Received:2013-04-07 Revised:2013-09-02 Online:2014-03-15 Published:2014-03-11

摘要: 为了探究UV辐照对棉纤维结构与性能的影响,详细分析了棉织物经不同时间的功率密度为100w/cm的UV照射后,棉织物的表面形态、聚合度、力学性能、热稳定性、白度的变化。结果表明:辐照时间的增加会使棉纤维结构与性能的损伤增大,当辐照时间达到30s,棉纤维的表面被刻蚀,表面粗糙度增加;在初始裂解阶段棉纤维的失重率略微增加,棉纤维最大失重速率温度下降8℃,热稳定性有所下降;棉织物白度下降7%,织物泛黄;棉纤维素大分子中共价键C―C、C―O断裂,棉织物的经向断裂强力下降约21%,纬向断裂强力下降约10%;棉纤维聚合度从692下降到140。随着辐照时间的进一步增大,棉纤维结构与性能的损伤程度增加会更大。

关键词: UV辐照, 棉纤维, 热稳定性, 聚合度, 断裂强力

Abstract: The cotton fabric was irradiated for different time under UV to investigate the changes of structure and properties of the irradiated cotton fiber when the power density of UV was 100w/cm. And the surface morphology, degree of polymerization, mechanical properties, thermal stability and whiteness of cotton fabric were discussed. The results indicated that the increase of irradiation time cloud lead to aggravation of injuries in structure and properties of the cotton fiber. When the cotton fabric was irradiated for 30s under UV, surface of the cotton fiber was etched and surface roughness of fiber was increased. The temperature at the largest weight loss rate of the irradiated cotton fiber was decreased by 8oC and during initial stage of weightlessness weight loss rate was slightly increased, which suggested that thermal stability was reduced. The whiteness of cotton fabric was dropped by 7% and cotton fabric became yellow. The covalent bonds C―C, C―O of cellulose were opened and breaking strength in warp and weft directions of the cotton fabric were reduced by 21% and 10%, respectively. The degree of polymerization of the cotton fiber was varied from 692 to 140. And it could be predicted that variation of structure and properties of cotton fiber would be enhanced with the continuous increase of irradiation time.

Key words: UV irradiation, cotton fiber, thermal stability, degree of polymerization, breaking strength

中图分类号: 

  • TS101.9
[1] 林启松 江力 汪凯 张顺花. 新型改性聚酯的制备及其性能[J]. 纺织学报, 2018, 39(08): 22-26.
[2] 陈丽丽 楼利琴 傅雅琴. 木棉纤维/棉混纺织物结构参数对其保暖透气性影响[J]. 纺织学报, 2018, 39(06): 47-51.
[3] 白婧 杨柳 张毅 张瑞云 马颜雪 俞建勇 程隆棣. 纯棉色纺纱配色中的Stearns-Noechel模型参数优化[J]. 纺织学报, 2018, 39(03): 31-37.
[4] 高娜 李强 徐伯俊 刘新金 王广斌. 不同引纱方法对云纹纱成纱外观及质量的影响[J]. 纺织学报, 2017, 38(12): 43-48.
[5] 俞俭 王业师 吕景春 周天池 魏取福. 低温等离子体处理木棉纤维的染色性能[J]. 纺织学报, 2017, 38(12): 88-94.
[6] 贾丽霞 金崇业 刘瑞 单国华. 硅磷杂化阻燃整理对羊毛结构与热稳定性能的影响[J]. 纺织学报, 2017, 38(12): 101-105.
[7] 吉强 王晓 戚俊然 崔永珠 吕丽华. 光接枝丙烯酸棉纤维素基TiO2/C光催化剂的制备与光催化性[J]. 纺织学报, 2017, 38(10): 75-80.
[8] 杨大伟 缪旭红 孙婉 蒋高明. 经编间隔织物的拉伸特征[J]. 纺织学报, 2017, 38(04): 55-60.
[9] 刘鹏雷 姜鹏飞 刘燕军 郑帼. 纺丝油剂中脂肪酸酯类平滑剂的抗氧化及热稳定性[J]. 纺织学报, 2017, 38(04): 68-72.
[10] 杨明杰 武海良 沈艳琴 姚一军 毛宁涛. 中低温条件下聚乳酸长丝的上浆机制[J]. 纺织学报, 2017, 38(03): 85-90.
[11] 崔红 高秀丽 张伟 吕立斌. 自捻纱的拉伸力学性能[J]. 纺织学报, 2017, 38(03): 44-48.
[12] 刘笑莹 方斌 朱守艾 程隆棣 张瑞云 俞建勇. 棉/大麻纤维混纺低损耗工艺优化[J]. 纺织学报, 2017, 38(01): 35-39.
[13] 苏玉恒 孔繁荣. 采用窗函数的棉纤维线密度分布表征[J]. 纺织学报, 2017, 38(01): 46-51.
[14] 王梦琴 王树根. 棉纤维阳离子化的简易定量检测方法[J]. 纺织学报, 2016, 37(4): 75-0.
[15] 李瑞雪 沈小林 张兴亚 肖杏芳 江珊 尹维维. 原位生成二氧化钛对棉纤维抗紫外线性能的影响[J]. 纺织学报, 2016, 37(3): 78-0.
Viewed
Full text


Abstract

Cited

  Shared   
  Discussed   
No Suggested Reading articles found!