纺织学报 ›› 2020, Vol. 41 ›› Issue (11): 150-155.doi: 10.13475/j.fzxb.20200301506

• 机械与器材 • 上一篇    下一篇

纬编针织机织针自由状态下固有频率测试方法

戴宁, 彭来湖(), 胡旭东, 崔英, 钟垚森, 王越峰   

  1. 浙江理工大学 浙江省现代纺织装备技术重点实验室, 浙江 杭州 310018
  • 收稿日期:2020-03-06 修回日期:2020-07-29 出版日期:2020-11-15 发布日期:2020-11-26
  • 通讯作者: 彭来湖
  • 作者简介:戴宁(1991—),男,博士生。主要研究方向为针织装备控制技术。
  • 基金资助:
    国家重点研发计划资助项目(2017YFB1304000)

Method for testing natural frequency of weft knitting needles in free state

DAI Ning, PENG Laihu(), HU Xudong, CUI Ying, ZHONG Yaosen, WANG Yuefeng   

  1. Key Laboratory of Modern Textile Machinery & Technology of Zhejiang Province, Zhejiang Sci-Tech University,Hangzhou, Zhejiang 310018, China
  • Received:2020-03-06 Revised:2020-07-29 Online:2020-11-15 Published:2020-11-26
  • Contact: PENG Laihu

摘要:

针对现有纬编针织机织针由于其结构尺寸微小、细长、横截面直径不定等特性带来的在其自由状态下织针的各阶模态特性难以测试的问题,提出采用小面积、低质量的锆钛酸铅压电陶瓷(PZT)贴于织针表面,形成PZT、织针黏合体结构。采用高性能阻抗分析仪对黏合体进行扫频测试,根据不同频率下复阻抗以及相位角曲线,得出PZT自由状态下的各阶模态。采用ANSYS有限元仿真软件对织针以及黏合体的各阶模态进行对比认证,并采用悬臂梁曲率、挠度理论以及织针振动理论进行分析。理论推算以及仿真测试结果表明,该实验测试方法能有效测试纬编针织机织针自由状态下的固有频率。

关键词: 纬编针织机, 织针, 复阻抗曲线, 相位角曲线, ANSYS有限元仿真, 振动特性

Abstract:

The natural frequency characteristics of knitting needles on weft knitting machines are closely related to the property of weft knitting machines. The existing weft knitting machine knitting needles are small, slender, and have variable cross-sectional diameter in their free state, and the characteristics of the knitting needles at various stages are difficult to test. This research made use of a small and low-quality piezoelectric zirconate titanate ceramics (PZT) attached to the surface of the knitting needle to form an adhesive body structure. A high-performance impedance analyzer was used to perform a frequency sweep test on the bonded body. According to the complex impedance and phase angle curves at different frequencies, the modes of each order in the PZT free state were obtained. ANSYS finite element simulation software was used to compare and verify each mode of knitting needles and bonded bodies, and analysis was performed based on the cantilever curvature, deflection theory, and knitting needle vibration theory. The results of theoretical calculation and simulation test show that this experimental test method is able to measure effectively the natural frequency of the needles in the free state.

Key words: weft knitting machine, knitting needle, complex impedance curve, phase angle curve, ANSYS finite element simulation, vibration characteristic

中图分类号: 

  • TS103.7

图1

纬编针织机成圈过程织针运动简图"

图2

织针固有频率总体设计方案简图"

图3

黏合体剖面结构图"

图4

实验连接图"

图5

阻抗分析仪测量黏合体固有频率原理"

图6

复阻抗-频率与角度-频率曲线图"

图7

弯曲时织针表面曲率示意图"

表1

试样1,2前3阶频率统计表"

试样编号 一阶频率 二阶频率 三阶频率
1 342.4 734.0 957.8
2 361.1 790.0 976.5

图8

织针前3阶模态分析结果图"

表2

织针仿真与测试结果误差结果汇总"

模态 仿真
频率/
Hz
实验1 实验2
测试
频率/Hz
测试
误差/%
测试
频率/Hz
测试
误差/%
1 383.1 342.4 10.6 361.1 5.7
2 896.7 734.0 18.1 790.0 11.9
3 1 019.0 957.8 6.0 976.5 4.2

图9

黏合体前3阶模态分析结果图"

表3

黏合体仿真与测试结果误差结果汇总"

模态 仿真
频率/
Hz
实验1 实验2
测试
频率/Hz
测试
误差/%
测试
频率/Hz
测试
误差/%
1 382.0 342.4 10.4 361.1 5.5
2 885.5 734.0 17.1 790.0 10.8
3 986.4 957.8 2.9 976.5 1.0
[1] 张华. 纬编针织机编织动力学分析及控制策略研究[D]. 杭州:浙江理工大学, 2013: 30-39.
ZHANG Hua. Dynamic analysis of knitting process and its control strategy study of weft knitting machine[D]. Hangzhou: Zhejiang Sci-Tech University, 2013: 30-39.
[2] 张成俊, 游良风, 左小艳. 电脑横机织针的磁驱动设计与建模[J]. 纺织学报, 2019,40(9):180-185.
ZHANG Chengjun, YOU Liangfeng, ZUO Xiaoyan. Magnetic driving design and modeling for knitting needles of computerized flat knitting machine[J]. Journal of Textile Research, 2019,40(9):180-185.
[3] 刘永春, 赵艳影. 一种悬臂梁模态测试方法[J]. 力学与实践, 2019,41(5):572-577.
LIU Yongchun, ZHAO Yanying. A modal testing method for cantilever beam[J]. Mechanics in Engineering, 2019,41(5):572-577.
[4] 唐冶, 王涛, 丁千. 主动控制压电旋转悬臂梁的参数振动稳定性分析[J]. 力学学报, 2019,51(6):1873-1880.
TANG Ye, WANG Tao, DING Qian. Stability analysis on parametric vibration of piezoelectric rotating cantilever beam with active control[J]. Chinese Journal of Theoretical and Applied Mechanics, 2019,51(6):1873-1880.
[5] 陈春松. 多路数圆型纬编针织机控制系统设计[D]. 杭州:浙江理工大学, 2012: 2-28.
CHEN Chunsong. Design of control system for multi-route circular weft knitting machine[D]. Hangzhou: Zhejiang Sci-Tech University, 2012: 2-28.
[6] 马创军. 圣东尼SM8-TOP1型无缝内衣机多色提花的编织[J]. 针织工业, 2009(7):8-9.
MA Chuangjun. The knitting technology of multi-color jacquard on the Santoni SM8-TOP1-type seamless underwear knitting machine[J].Knitting Industries, 2009(7):8-9.
[7] 龙海如. 针织学[M]. 北京: 中国纺织出版社, 2008: 1-26.
LONG Hairu. Knitting Textiles[M]. Beijing: China Textile & Apparel Press, 2008: 1-26.
[8] DURU S C, CANDAN C, MUGAN A. Effect of yarn, machine and knitting process parameters on the dynamics of the circular knitting needle[J]. Textile Research Journal, 2015,85(6):568-589.
[9] LONG H R. The effect of the shape and parameters of the knitting needle on cam-to-needle impact forces[J]. Journal of The Textile Institute, 2000,91(2):259-267.
[10] 方园, 夏凡甜, 居婷婷, 等. 基于SolidWorks建模技术的双针筒电脑袜机成圈机件有限元仿真分析[J]. 纺织学报, 2012,33(9):135-142.
FANG Yuan, XIA Fantian, JU Tingting, et al. Finite-element simulation and analysis of double-cylinder computerized hosiery machine's knitting element based on Solidworks modeling technology[J]. Journal of Textile Research, 2012,33(9):135-142.
[1] 戴宁, 彭来湖, 胡旭东, 崔英, 钟垚森, 王越锋. 基于Euler-Bernoulli 梁理论的无缝内衣机织针编织过程固有频率特性研究[J]. 纺织学报, 2020, 41(12): 144-150.
[2] 朱世根, 杨宏贤, 白云峰, 丁浩, 朱巧莲. 长条状细薄带钩零件变形自动检测系统[J]. 纺织学报, 2020, 41(10): 158-163.
[3] 李冬冬, 张成俊, 左小艳, 张弛, 李红军, 周向阳. 混合磁悬浮织针驱动的永磁织针磁场分布规律[J]. 纺织学报, 2020, 41(09): 136-142.
[4] 张成俊, 游良风, 左小艳, 张弛, 朱里. 电脑横机织针的磁驱动设计与建模[J]. 纺织学报, 2019, 40(09): 180-185.
[5] 徐洋 程福荣 盛晓伟 孙志军 余智祺. 纱线束横向动态振动特性仿真与实验[J]. 纺织学报, 2018, 39(05): 113-118.
[6] 吴晓光 朱里 张驰 孔令学 万道玉. 零传动模式的高速轴向悬浮织针运动控制与试验分析[J]. 纺织学报, 2016, 37(4): 137-142.
[7] 金玉珍 胡小冬 林培锋 胡旭东. 喷气织机打纬机构及墙板的振动特性[J]. 纺织学报, 2016, 37(07): 131-136.
[8] 徐艳华 袁新林. 玄武岩纤维机织针织复合织物增强复合材料的弯曲性能[J]. 纺织学报, 2013, 34(1): 36-39.
[9] 徐艳华, 袁新林. 机织针织复合织物与多层双轴向纬编织物拉伸性能对比[J]. 纺织学报, 2012, 33(6): 30-34.
[10] 高晓平, 孙心泽, 孟婥, 徐洋, 孙志军. 簇绒提花地毯纱线束动态张力分析[J]. 纺织学报, 2012, 33(2): 40-45.
[11] 吴晓光 孔令学 朱里 武玉琴 黄振 李爽. 磁悬浮式针织提花驱动方式理论研究与探讨[J]. 纺织学报, 2012, 33(10): 128-133.
[12] 徐艳华;袁新林;胡红. 玄武岩纤维机织针织复合结构增强复合材料的拉伸性能[J]. 纺织学报, 2011, 32(2): 48-52.
[13] 鲍正红;朱世根;丁浩;狄平. 回火工艺对织针弹性及硬度的影响[J]. 纺织学报, 2008, 29(4): 119-122.
[14] 陈海燕;朱世根;丁浩;季诚昌;沈剑;原一高;顾伟生. 基于ANSYS的织针淬火加热过程的温度场模拟[J]. 纺织学报, 2006, 27(4): 44-47.
Viewed
Full text


Abstract

Cited

  Shared   
  Discussed   
No Suggested Reading articles found!