纺织学报 ›› 2017, Vol. 38 ›› Issue (11): 131-136.doi: 10.13475/j.fzxb.20160902706

• 机械与器材 • 上一篇    下一篇

含纱疵纱线的气流引纬牵引特性分析

  

  • 收稿日期:2016-09-18 修回日期:2017-08-11 出版日期:2017-11-15 发布日期:2017-11-15

Analysis on airflow drag characteristics of yarn with yarn faults

  • Received:2016-09-18 Revised:2017-08-11 Online:2017-11-15 Published:2017-11-15

摘要:

为探究纱疵对气流牵引纱线的影响,根据纱疵在流体中的形状特性,提出以球体或圆柱体模型化短粗节纱疵新设想。基于Fluent的流场分析结果,对短粗节纱疵牵引力进行了数值计算,通过自行设计的主喷嘴气流引纬牵引力测试装置,测定了短粗节纱疵模型球体在0.3 MPa供气压力下的气流牵引力大小,并对前述数值计算结果的合理性进行了验证,得到较好的一致性。同时,探究了纱疵对纱线牵引力系数的影响效应,结果表明:随着纱疵直径增大,纱线牵引力系数的变化率呈先上升,随后逐渐趋于平缓现象;而随着纱疵数量的增多,牵引力系数的变化率呈逐次下降态势。

关键词: 纱线, 纱疵, 气流牵引, 数值计算, 牵引力系数

Abstract:

In order to study the influence of yarn faults on airflow drags yarn, a assumption simulate short slub yarn faults by spheres and cylinders was proposed firstly according to the shape feature of yarn faults in airflow. The drag force of short slub yarn faults were numerical calculated based on analyze airflow results by Fluent. The drag forces of spheres as model of short slub yarn faults were tested by self-designed testing drag force device for main-nozzle air-jet weft insertion under 0.3 MPa inlet pressure. The rationality of numerical calculation that previous statement was verified , and the consistency was obtained. Finally, the influence effect of short slub yarn faults on drag coefficient was studied. Conclusions were found that the rate of change for coefficient of drag force increased firstly then verged to stabilization gradually with the diameter of yarn faults increasing. In addition, the change rate for coefficient of drag force presented descending tendency gradually with increase of the quantity of yarn faults.

Key words: yarn, yarn fault, air drag, numerical calculation, coefficient of drag force

[1] 陆奕辰 王蕾 唐千惠 潘如如 高卫东. 应用图像处理的纱线黑板毛羽量检测与评价[J]. 纺织学报, 2018, 39(08): 144-149.
[2] 喻飞 王静安 潘如如 周建 高卫东. 数码纱的外观效果仿真方法[J]. 纺织学报, 2018, 39(07): 148-152.
[3] 万振凯 李鹏 贾敏瑞 包玮琛 裘旭光. 智能复合材料中碳纳米管纱线参数设计及其变化特征[J]. 纺织学报, 2018, 39(06): 58-63.
[4] 徐洋 程福荣 盛晓伟 孙志军 余智祺. 纱线束横向动态振动特性仿真与实验[J]. 纺织学报, 2018, 39(05): 113-118.
[5] 张岩 裴泽光 陈革. 喷气涡流纺金属丝包芯纱的制备及其结构与性能[J]. 纺织学报, 2018, 39(05): 25-31.
[6] 王双 刘玮 刘晓霞 许福军 程琼 王晶. 嵌入机织物的碳纳米管纱线应变传感性能[J]. 纺织学报, 2018, 39(05): 43-48.
[7] 胡瑜 刘行 缪旭红. 经编纱线动态张力评价指标[J]. 纺织学报, 2018, 39(02): 68-72.
[8] 韩晨晨 程隆棣 高卫东 薛元 薛文良 杨瑞华 . 传统型与自捻型喷气涡流纺的对比[J]. 纺织学报, 2018, 39(01): 25-31.
[9] 杨瑞华 薛元 郭明瑞 王鸿博 周建 高卫东. 数码转杯纺成纱原理及其纱线特点[J]. 纺织学报, 2017, 38(11): 32-35.
[10] 刘让同 李亮 刘淑萍 田广菓 李淑静 朱雪莹 弋梦梦. 机织物结构相模型剖析和修正[J]. 纺织学报, 2017, 38(10): 32-37.
[11] 王元峰 冯艳飞 夏治刚 . 复合纱体中长丝分布形态对纱线性能的影响[J]. 纺织学报, 2017, 38(09): 32-39.
[12] 孙银银 张宁 吴洋 潘如如 高卫东. 纱线毛羽骨架及长度的跟踪测量[J]. 纺织学报, 2017, 38(08): 32-38.
[13] 罗婷 纪峰 程隆棣 吉宜军 邓万胜. 双S曲线软牵伸纺纱技术[J]. 纺织学报, 2017, 38(07): 34-38.
[14] 魏晓婷 薛元 郭明瑞 张继东 高卫东. 三通道数码细纱机纺制竹节纱的原理及其性能[J]. 纺织学报, 2017, 38(07): 39-43.
[15] 杜玲玲 李婷婷 潘婧 周宝明 . 芳纶/不锈钢长丝包芯纱织物的制备及其防刺性能[J]. 纺织学报, 2017, 38(06): 33-39.
Viewed
Full text


Abstract

Cited

  Shared   
  Discussed   
No Suggested Reading articles found!