纺织学报 ›› 2017, Vol. 38 ›› Issue (05): 8-13.doi: 10.13475/j.fzxb.20160407606

• 纤维材料 • 上一篇    下一篇

聚乳酸-聚己内酯/丝素蛋白三元复合纳米纤维膜支架的结构与性能

  

  • 收稿日期:2016-04-27 修回日期:2017-02-12 出版日期:2017-05-15 发布日期:2017-05-16

Structure and properties of polylactic acid-polycaprolactone/silk fibroin composite nanofibrous scaffolds

  • Received:2016-04-27 Revised:2017-02-12 Online:2017-05-15 Published:2017-05-16

摘要:

通过静电纺丝技术制备出不同质量比的聚乳酸聚己内酯/ 丝素蛋白(PLA-PCL/SF)复合纳米纤维膜支架,采用扫描电子显微镜、傅里叶红外光谱仪对纳米纤维膜的形貌和结构进行表征,测试纤维膜的孔隙率和吸附性能。结果表明:PLA-PCL与SF 这2 种组分的质量比对复合纳米纤维膜的形貌有显著影响,质量比为90:10和70:30的纳米纤维表面分布着密集的孔洞;PLA-PCL/SF复合纳米纤维膜中SF 经甲醇处理后由无定形结构转变为β?折叠结构;随着复合纳米纤维膜中SF 含量的增加,纳米纤维膜的孔隙率和吸附性也逐渐降低。接触角实验和小鼠胚胎成纤维细胞(NIH-3T3)培养结果表明,SF的加入提高了纳米纤维膜的亲水性,有利于NIH-3T3细胞的黏附和增殖。

关键词: 聚乳酸, 聚己内酯, 丝素蛋白, 静电纺丝, 纳米纤维膜支架, 生物相容性

Abstract:

Poly(lactic acid-polycaprolactone/silk fibroin (PLA-PCL/SF) composite nanofibrous scaffolds with different mass ratios were fabricated by electrospinning. The morphologies and structures of nanofibrous mats were characterized by scanning electron microscopy (SEM) and Fourier transform infrared spectroscopy (FT-IR). The porosity and adsorbent behavior of the fibrous mats were also measured. The results shows that the mass ratio of PLA-PCL and SF components had obvious influence on the morphologies of nanofibrous scaffolds, and high density pores present on nanofibrous surface at mass ratios of 90:10 and 70:30 . The structure of SF in PLA-PCL/SF composite scaffolds is shanged from amorphous structure to β-sheet conformation by methanol treatment. The porosity and adsorbent behavior of the nanofibrous mats decrease with increasing SF contents in composite nanofibrous scaffolds. The water contact angle test and mouse fibroblasts cells (NIH-3T3) culture results indicate that the hydrophilicity of nanofibrous scaffolds is improved by the addition of SF for better adhesion and proliferation of NIH-3T3 cells.

Key words: polylactic acid, polycaprolactone, silk fibroin, electrospinning, nanofibrous scaffold, biocompatibility

[1] 赵作显 洪剑寒 严喆 潘志娟. 生物可降解聚(3-羟基丁酸-co-3-羟基戊酸共聚酯)/聚乳酸共混物的相容性和结晶性[J]. 纺织学报, 2018, 39(08): 1-8.
[2] 吴小娟 余妙晶 舒慧 郑怡筱 葛烨倩 . 过温保护层合纳米纤维隔膜的制备及其性能[J]. 纺织学报, 2018, 39(07): 21-26.
[3] 陈洪立 焦晓宁 柯鹏. 取向增强复合锂离子电池隔膜的制备及其性能[J]. 纺织学报, 2018, 39(07): 8-14.
[4] 张博亚 李佳慧 张如全 李建强. 静电纺聚丙烯腈/硫酸铜纳米纤维膜的制备及其性能[J]. 纺织学报, 2018, 39(07): 15-20.
[5] 王航 庄旭品 董锋 石磊 康卫民 徐先林 程博闻. 溶液喷射纺纳米纤维制备技术及其应用进展[J]. 纺织学报, 2018, 39(07): 165-173.
[6] 姚勇波 颜志勇 李喆 易洪雷 张玉梅 王华平. 牵伸倍率分配对纤维素/丝素蛋白共混纤维形态结构的影响[J]. 纺织学报, 2018, 39(06): 13-18.
[7] 程燕婷 孟家光 支超. 以柔性聚乳酸为材料的织物组织立体打印参数设计[J]. 纺织学报, 2018, 39(05): 38-42.
[8] 李鹏飞 邓桦 马军 刘红斌 刘珍珠. 再生丝素蛋白溶液脱盐新工艺及其应用[J]. 纺织学报, 2018, 39(05): 20-24.
[9] 王迎 杨云 魏春艳 宋欢 季英超 孙玉雍 张欣. 沉积静电纺聚丙烯腈纳米纤维膜窗纱的制备及其性能[J]. 纺织学报, 2018, 39(04): 14-18.
[10] 王宗乾 杨海伟 王邓峰. 脱胶对蚕丝纤维的溶解及丝素蛋白性能的影响[J]. 纺织学报, 2018, 39(04): 69-76.
[11] 靳世鑫 辛斌杰 郑元生. 静电纺丝法宏量制备纳米纤维的研究进展[J]. 纺织学报, 2018, 39(03): 175-180.
[12] 刘雷艮 林振锋 沈忠安 牛建涛. 静电纺多孔超细纤维膜的吸油性能[J]. 纺织学报, 2018, 39(02): 7-13.
[13] 蒋洁 陈胜 李静静 付润芳 林义 顾迎春. 静电纺钛酸钡/聚偏氟乙烯纳米复合柔性压电纤维膜[J]. 纺织学报, 2018, 39(02): 14-19.
[14] 李静静 卢辉 蒋洁 张思航 顾迎春 陈胜. 高压电性静电纺柔性氧化锌/聚偏氟乙烯复合纤维膜[J]. 纺织学报, 2018, 39(02): 1-6.
[15] 王永鹏 刘梦竹 路大勇. 用静电纺丝法制备可交联高性能聚合物纳米纤维[J]. 纺织学报, 2018, 39(01): 6-10.
Viewed
Full text


Abstract

Cited

  Shared   
  Discussed   
No Suggested Reading articles found!