Journal of Textile Research ›› 2021, Vol. 42 ›› Issue (01): 84-89.doi: 10.13475/j.fzxb.20200403306

• Dyeing and Finishing & Chemicals • Previous Articles     Next Articles

Preparation of compound antistatic spinning oil for bio-based polyamide 56 and its effect on staple fiber spinnability

WANG Ying1, WANG Yiting1, WU Jiaqing1, GUO Yafei2, HAO Xinmin2()   

  1. 1. School of Textile and Material Engineering, Dalian Polytechnic University, Dalian, Liaoning 116034, China
    2. Institute of Quartermaster Engineering & Technology, Institute of System Engineering, Academy of Military Sciences, Beijing 100082, China
  • Received:2020-04-14 Revised:2020-09-27 Online:2021-01-15 Published:2021-01-21
  • Contact: HAO Xinmin E-mail:xminhao@126.com

RichHTML

5

PDF (PC)

125

Abstract:

Aiming at the problems of high mass specific resistance, serious static electricity and poor spinnability of bio-based polyamide 56 (PA56) staple fibers, a spinning oil was developed using the compound technology of commercial oil and antistatic agent. The influence of antistatic agent concentration on the conductivity and pH value of the compound oil was studied. The surface morphology, friction coefficient, mass specific resistance and carding performance of the bio-based PA56 staple fibers were investigated. The results showed that a smooth and uniform oil film was formed on the fiber surface after the compound oil treatment. The optimum concentration of antistatic agent and spinning oil were 2 g/L and 12 g/L respectively. Under this condition, a fiber-web from the PA56 staples was formed at the relative humidity of 35% and room temperature, which was uniform without holes and cloud spots. This compound spinning oil improves the bunching, antistatic and spinnability of PA56 staple fibers. It is a green and energy-saving method, requiring only for ambient temperature and humidity of spinning workshop.

Key words: bio-based polyamide fiber, antistatic performance, spinning oil, compound oil, spinnability

CLC Number: 

  • TS154

Tab.1

Compound method of antistatic agent and spinning oil"

试样编号 抗静电剂质量浓度/
(g·L-1)		 市售油剂质量浓度/
(g·L-1)
N0 0.00 0
Y0 0.00 12
E1 0.05 12
E2 0.10 12
E3 0.20 12
E4 0.60 12
E5 1.00 12
E6 2.00 12
E7 4.00 12
E8 6.00 12
E9 8.00 12
E10 10.00 12

Fig.1

Conductivity of compound spinning oil"

Fig.2

pH value of compound spinning oil"

Tab.2

Relationship between oil characteristics,fiber friction coefficient and spinnability"

类别 效果 油剂特性 摩擦因数要求
成网性 均匀 平滑性、抱合性 μs大,μd小
棉条蓬松 小 抱合性、抗静电性 μs大
堵喇叭口 不堵 平滑性、抗静电性 μs大,μd小
牵伸斑 少 平滑性 μs大,μd小
棉条断落 少 抱合性、平滑性 μs大,μd小
成纱强力 高 抱合性 μs大

Tab.3

Static friction coefficient of PA56 staple"

试样编号 静摩擦因数 试样编号 静摩擦因数
Y0 0.432 0 E6 0.466 9
E1 0.433 4 E7 0.491 9
E2 0.426 9 E8 0.558 0
E3 0.445 7 E9 0.564 2
E4 0.439 3 E10 0.504 6
E5 0.437 2

Fig.3

Mass specific resistance of PA56 staple"

Fig.4

SEM images of PA56 staple(×2 000)"

Fig.5

EDS spectra of PA56 staple"

Fig.6

Combing effect of PA56 staple"

[1] 邓洁, 高震, 高华, 等. 生物酶法合成1,5戊二胺的研究进展[J]. 广西科学, 2017,24(1):40-47.
DENG Jie, GAO Zhen, GAO Hua, et al. Research progress of the bio-synjournal of l,5 diamin-opentane[J]. Guangxi Sciences, 2017,24(1):40-47.
[2] 马雪松, 徐晓晨, 陈英. 生物基化学纤维PA56的性能与应用[J]. 纺织导报, 2019 (8):43-46.
MA Xuesong, XU Xiaochen, CHEN Ying. Performance and application of bio-based PA56 Fiber[J]. China Textile Leader, 2019 (8):43-46.
[3] 董奎勇, 杨婷婷, 王学利, 等. 生物基聚酯与聚酰胺纤维的研发进展[J]. 纺织学报, 2020,41(1):174-182.
DONG Kuiyong, YANG Tingting, WANG Xueli, et al. Research and development progress of bio-based polyester and polyamide fibers[J]. Journal of Textile Research, 2020,41(1):174-182.
[4] LAURA Morales Gámez, DAVID Soto, LOURDES Franco, et al. Brill transition and melt crystallization of nylon 56: an odd-even polyamide with two hydrogen-bonding directions[J]. Polymer, 2010(51):5788-5798.
[5] 郝新敏, 李岳玲, 王建明, 等. 锦纶纤维酸性染料染色动力学对比研究[J]. 纺织学报, 2015,36(2):77-80.
HAO Xinmin, LI Yueling, WANG Jianming, et al. Study on acid dyestuff dyeing kinetics of polyamide 56 fiber compared with polyamide 6 and 66[J]. Journal of Textile Research, 2015,36(2):77-80.
[6] WANG Yu, KANG Hongliang, WANG Rui, et al. Crystallization of polyamide 56/polyamide 66 blends: non-isothermal crystallization kinetics[J]. Journal of Applied Polymer Science, 2018,46409:1-13.
[7] GUO Yafei, HAO Xinmin, LI Yueling, et al. Evaluate on the alkaline resistance properties of bio-based nylon 56 fiber compared with the normal nylon fibers[J]. Advanced Materials Research, 2014,1048:31-35.
[8] WANG Yu, KANG Hongliang, GUO Yafei, et al. The structures and properties of bio-based polyamide 56 fibers prepared by high-speed spinning[J]. Journal of Applied Polymer Science, 2020,49344:1-13.
[9] 孙禹, 戴桦根. 浅谈锦纶FDY油剂[J]. 化纤与纺织技术, 2009(1):42-45.
SUN Yu, DAI Huagen. Nylon FDY oil[J]. Chemical Fiber & Textile Technology, 2009(1):42-45.
[10] 郑帼, 刘燕军, 徐进云, 等. 涤纶短纤油剂及其摩擦性能[J]. 纺织学报, 2005,26(3):85-88.
ZHENG Guo, LIU Yanjun, XU Jinyun, et al. Polyester staple finishes and its fractional property[J]. Journal of Textile Research, 2005,26(3):85-88.
[1] ZHANG Anying, WANG Zhaoying, WANG Rui, DONG Zhenfeng, WEI Lifei, WANG Deyi. Preparation and structural properties of flame retardant poly(L-lactic acid) and fiber thereof [J]. Journal of Textile Research, 2019, 40(04): 7-14.
[2] . Preparation and properties of high strength and high modulus polyoxymethylene fibers [J]. Journal of Textile Research, 2018, 39(10): 1-6.
[3] . Preparation and performance of pentaerythritol phosphate/zine diethyl phosphate synergistic flame retardant polyamide 6 [J]. Journal of Textile Research, 2018, 39(09): 8-14.
[4] . Oxidation resistance and thermal stability of fatty acid esters lubricant agent in spinning oil [J]. JOURNAL OF TEXTILE RESEARCH, 2017, 38(04): 68-72.
[5] . Study on spinnability of biodegradable Poly(3-hydroxybutyrate-co-3-hydroxyvalerate) / poly(lactic acid) blends for melt-blown nonwovens [J]. Journal of Textile Research, 2016, 37(2): 21-26.
[6] . Construction of raw cotton spinnability index based on principal component analysis [J]. JOURNAL OF TEXTILE RESEARCH, 2015, 36(08): 16-21.
[7] . Environment-friendly processing technology and application of bio-based polyamide fiber [J]. Journal of Textile Research, 2015, 36(04): 160-164.
[8] . Research on the spinnability of Poly(lactic acid)/ Poly(3-hydroxybutyrate-co-3-hydroxyvalerate) two-component biodegradable materials for spun-bonded nonwovens [J]. JOURNAL OF TEXTILE RESEARCH, 2014, 35(9): 19-0.
[9] . Influence of saw type lint cleaning on performance of machine stripped cotton [J]. JOURNAL OF TEXTILE RESEARCH, 2014, 35(1): 35-0.
[10] FENG SONG. Rheological properties during capillary extrusion of linear low density polyethylene [J]. JOURNAL OF TEXTILE RESEARCH, 2013, 34(6): 13-15.
[11] . Effect of electret particles on thermal properties and spinnability of PLA meltblown materials [J]. JOURNAL OF TEXTILE RESEARCH, 2013, 34(2): 82-85.
[12] . Spinning process of multifunctional flame retardancy polyester fibers [J]. JOURNAL OF TEXTILE RESEARCH, 2013, 34(1): 1-6.
[13] . Analysis on materials of sodium alginate spinning solutions [J]. JOURNAL OF TEXTILE RESEARCH, 2010, 31(2): 1-6.
[14] JI Yingchao;JIANG Fengqin;ZHAO Yuping. Selection of fiber-type hemp varieties [J]. JOURNAL OF TEXTILE RESEARCH, 2010, 31(12): 19-22.
[15] WANG Rui;LI Shufeng;HUANG Junpeng. Rheological behavior of EVOH [J]. JOURNAL OF TEXTILE RESEARCH, 2009, 30(02): 9-12.
Viewed
Full text


Abstract

Cited
  Shared   
  Discussed   
No Suggested Reading articles found!
京ICP备14006648号
Copyright 2021 © Editorial office of Journal of Textile Research
Supported by Beijing Magtech Co.Ltd