Journal of Textile Research ›› 2021, Vol. 42 ›› Issue (02): 107-112.doi: 10.13475/j.fzxb.20200706106

• Textile Engineering • Previous Articles     Next Articles

Simulation on tensile properties of tubular weft knitted fabrics based on ABAQUS

SUN Yabo1, LI Lijun2,3, MA Chongqi1(), WU Zhaonan1, QIN Yu1   

  1. 1. School of Textile Science and Engineering, Tiangong University, Tianjin 300387, China
    2. School of Automation, Southeast University, Nanjing, Jiangsu 210096, China
    3. Ninbo Cixing Co., Ltd., Ningbo, Zhejiang 315336, China
  • Received:2020-07-22 Revised:2020-11-02 Online:2021-02-15 Published:2021-02-23
  • Contact: MA Chongqi E-mail:tjmcq@tjpu.edu.cn

RichHTML

24

PDF (PC)

235

Abstract:

In order to better understand the tensile deformation capability of tubular weft knitted fabrics, a three-dimensional weft knitted fabric loop model and a tubular weft knitted fabric model were established using a three-dimensional modeling software Rhino, on the basis of the measured fabric structure parameters. The tensile properties of the fabric were simulated on unit loop level and tubular fabric level using the finite element analysis software ABAQUS. Numerical simulations of fabric tensile process were studied and corresponding experiment verification was carried out. Deformation and stress distribution of yarns in the stretching process of knitted fabrics were analyzed and discussed. The results indicate that when fabrics are stretched along the length direction, the finite element analysis results of its deformation and stress change are described accurately compared to the experimental results. Moreover, the difference in stress and strain values between the simulated and the experimental results is about 8%, indicating that the numerical simulation is feasible and effective.

Key words: tubular weft knitted fabric, geometric model of knitted fabric, tensile mechanical property, finite element simulation

CLC Number: 

  • TS101.8

Fig.1

Coil type value point. (a) Front view of coil center line;(b)Left view of coil center line"

Tab.1

Coil type value point coordinates"

型值点 坐标 型值点 坐标
n1 (-2a, 0, r) n6 (a+0.5c, b+l, 0)
n2 (0.5c-a, b, 0) n7 (a, b+0.5l,-r)
n3 (-a, b+0.5l, -r) n8 (a-0.5c, b, 0)
n4 (-a-0.5c, b+l, 0) n9 (2a, 0, r)
n5 (0, 2b+l, r)

Fig.2

Three-dimensional model of coil"

Fig.3

Tubular knitted fabric model"

Tab.2

Tensile properties parameters of yarns"

密度/
(g·cm-3)		 强力/
cN		 伸长
率/%		 屈服应
力/MPa		 弹性模
量/MPa		 泊松比
0.92 579.80 7.48 19.61 1 829.36 0.20

Fig.4

Unit model load setting"

Fig.5

Stress distribution of unit model during tensile process. (a)Stress distribution when unstretched;(b)Stress distribution in early stage;(c)Stress distribution at end"

Fig.6

Stress distribution of tubular knitted fabric after stretching"

Fig.7

Comparison of fabric stress-strain between simulation and experiment"

Tab.3

Comparison of simulated and experimental results"

应变/% 应力实验值/MPa 应力理论值/MPa 误差/%
5 0.085 0.088 4.01
10 0.261 0.282 7.4
15 0.774 0.798 2.1
20 1.253 1.236 1.3
25 1.830 1.985 7.8
30 2.814 2.997 6.1
35 3.827 3.694 3.6
[1] 李瑛慧, 谢春萍, 刘新金, 等. 真丝和涤纶仿真丝织物的拉伸性能有限元仿真[J]. 丝绸, 2018,55(3):27-31.
LI Yinghui, XIE Chunping, LIU Xinjin, et al. Finite element simulation of tensile mechanical properties of silk fabrics and polyester silk-like fabrics[J]. Journal of Silk, 2018,55(3):27-31.
[2] 谭磊, 胡心怡. 拉伸方向对针织物断裂强力和断裂伸长的影响[J]. 天津工业大学学报, 2001 (5):53-55.
TAN Lei, HU Xinyi. Affection of tensile direction on the break strength and stretch of knitted fabrics[J]. Journal of Tiangong University, 2001(5):53-55.
[3] 潘月, 岑洁, 游晓悦, 等. 服用织物拉伸性能的各向异性分析[J]. 浙江理工大学学报, 2015,33(11):733-737, 743.
PAN Yue, CEN Jie, YOU Xiaoyue, et al. Anisotropic analysis of fabric tensile property[J]. Journal of Zhejiang Sci-Tech University, 2015,33(11):733-737,743.
[4] WANG Z, HU H. A finite element analysis of an auxetic warp-knitted spacer fabric structure[J]. Textile Research Journal, 2014,85(4):404-415.
[5] 李瑛慧, 谢春萍, 刘新金. 三原组织织物拉伸力学性能有限元仿真[J]. 纺织学报, 2017,38(11):41-47.
LI Yinghui, XIE Chunping, LIU Xinjin. Finite element simulation on tensile mechanical properties of three-elementary weave fabric[J]. Journal of Textile Research, 2017,38(11):41-47.
[6] GHORBANI E, HASANI H, JAFARI N R. Finite element modelling the mechanical performance of pressure garments produced from elastic weft knitted fabrics[J]. Journal of The Textile Institute, 2018,110(5):724-731.
[7] 刘倩楠, 张涵, 刘新金, 等. 基于ABAQUS的三原组织机织物拉伸力学性能模拟[J]. 纺织学报, 2019,40(4):44-50.
LIU Qiannan, ZHANG Han, LIU Xinjin, et al. Simulation on tensile mechanical properties of three-elementary weave woven fabrics based on ABAQUS[J]. Journal of Textile Research, 2019,40(4):44-50.
[8] 任工昌, 崔延琳, 杨君顺. 基于Rhino_3D的工业产品造型设计[J]. 包装工程, 2008 (1):124-126.
REN Gongchang, CUI Yanlin, YANG Junshun. Shape design of industrial product based on Rhino-3D[J]. Packaging Engineering, 2008 (1):124-126.
[9] 沙莎, 蒋高明. 纬编针织物三维模拟技术的研究现状与发展趋势[J]. 纺织学报, 2016,37(11):166-172.
SHA Sha, JIANG Gaoming. Research status and development trend of 3-D simulation technology for weft knitted fabric[J]. Journal of Textile Research, 2016,37(11):166-172.
[10] 石若星, 钟智丽, 万佳. 玄武岩长丝/芳纶间隔纱织物复合板材平压性能的有限元模拟[J]. 轻纺工业与技术, 2018,47(11):15-16,31.
SHI Ruoxing, ZHONG Zhili, WAN Jia. Finite element simulation of flat compression performance of basalt filament/aramid spacer yarn fabric composite sheet[J]. Light and Textile Industry and Technology, 2018,47(11):15-16,31.
[11] 吴济宏. 针织物结构与力学性能及其对服装压的影响[D]. 上海:东华大学, 2012: 105-107.
WU Jihong. Study on structures and mechanical properties of knitted fabric and its influence on the clothing pressure[D]. Shanghai: Donghua University, 2012: 105-107.
[1] DAI Ning, PENG Laihu, HU Xudong, CUI Ying, ZHONG Yaosen, WANG Yuefeng. Method for testing natural frequency of weft knitting needles in free state [J]. Journal of Textile Research, 2020, 41(11): 150-155.
[2] ZHANG Zhuhui, ZHANG Diantang, QIAN Kun, XU Yang, LU Jian. Weaving process and off-axial tensile mechanical properties of wide-angle woven fabric [J]. Journal of Textile Research, 2020, 41(08): 27-31.
[3] . Tensile mechanical properties simulation of viscose woven fabrics based on ABAQUS [J]. Journal of Textile Research, 2018, 39(09): 39-43.
[4] . Simulation of steady heat transfer on fabrics system embedded with heating unit in electrically heated clothing [J]. JOURNAL OF TEXTILE RESEARCH, 2018, 39(05): 49-55.
[5] . Finite element simulation on tensile mechanical properties of three-elementary weave fabric [J]. JOURNAL OF TEXTILE RESEARCH, 2017, 38(11): 41-47.
[6] . Numerical simulation of tensile properties of polytetrafluoroethylene/Kevlar broken twill fabric liner [J]. JOURNAL OF TEXTILE RESEARCH, 2016, 37(07): 71-76.
Viewed
Full text


Abstract

Cited
  Shared   
  Discussed   
No Suggested Reading articles found!
京ICP备14006648号
Copyright 2021 © Editorial office of Journal of Textile Research
Supported by Beijing Magtech Co.Ltd