Journal of Textile Research ›› 2021, Vol. 42 ›› Issue (03): 77-81.doi: 10.13475/j.fzxb.20200705005

• Textile Engineering • Previous Articles     Next Articles

Analysis of back draft effect and yarn structure of Siro fancy yarn with special appearance structure

RUAN Li1, SUN Rongji1, LIU Jihong1, LI Yonggui2   

  1. 1. Key Laboratory of Eco-Textiles (Jiangnan University), Ministry of Education, Wuxi, Jiangsu 214122, China
    2. Engineering Research Center of Textile and Clothing of Fujian Province University, Fuzhou, Fujian 350108, China
  • Received:2020-07-20 Revised:2020-12-04 Online:2021-03-15 Published:2021-03-17

RichHTML

4

PDF (PC)

53

Abstract:

In order to develop a new type of fancy yarn, the grooved back-top roller was used on the spinning frame, and the force of the rear nip strand of fibers and yarn structure with the fancy rubber-covered roll were analyzed. Tested on the TH598J spinning frame, the mass distribution of the whiskers output from the middle roller after one rotation of the tuber roller was measured by the cut-off weighing method, and the mass distribution of the whiskers output from the normal rubber roller and the fancy yarn rubber roller was obtained respectively. The draft curve of the back zone of normal rubber roller and fancy yarn rubber roller is obtained respectively by the draft formula, at the same time the density of the formed yarn analyzed, so as to explore the change of the appearance structure of this fancy yarn. The results indicate that the grooved rubber roller gradually reduces the draft ratio of the rear zone from normal to 1 and then gradually increases to normal. The section of the strand of fibers passing through the groove affects the draft of the front and back sections of the strand of fibers. The draft ratio is reduced from normal, so that the yarn density also changes, and a new type of Siro fancy yarn with a special appearance structure is obtained.

Key words: rubber-covered roll, back draft, slipping draft, fancy yarn, Siro-spinning, spinning

CLC Number: 

  • TS104.7

Fig.1

Back-top roller for Siro new fancy yarn"

Fig.2

Force analysis under rear clamp"

Fig.3

Longitudinal of Siro new fancy yarn"

Tab.1

Spinning parameters"

工艺参数 设定值
总牵伸倍数 29
后区牵伸倍数 1.6
后区罗拉中心距/mm 60
前罗拉转速/(r·min-1) 130
钳口隔距/mm 3.5
后罗拉上胶辊直径/mm 30

Fig.4

Mass distribution of strand of fibers output from the middle roller"

Fig.5

Back drafting changes of new fancy yarn"

Fig.6

Longitudinal structure changes of new fancy yarn"

[1] 陈玉峰. 混纺麻纱用新型牵伸器材效果分析[J]. 纺织器材, 2019,46(6):31-35.
CHEN Yufeng. Effect analysis of new drafting accessories for blended hemp yarn[J]. Textile Accessories, 2019,46(6):31-35.
[2] 杨锁廷, 刘建中, 季益萍, 等. 再论半精梳纺纱加工的关键技术[J]. 毛纺科技, 2012,40(3):13-16.
YANG Suoting, LIU Jianzhong, JI Yiping, et al. Discuss the key technologies of semi-combed spinning again[J]. Wool Textile Journal, 2012,40(3):13-16.
[3] 王瑞洁, 李龙, 秦彩霞. 采用滑溜牵伸的低比例山羊绒混纺纺纱实践[J]. 纺织学报, 2018,39(6):24-28.
WANG Ruijie, LI Long, QIN Caixia. Spinning of low-ratio cashmere blends under slipping draft[J]. Journal of Textile Research, 2018,39(6):24-28.
[4] 程浩南, 蒋丽萍, 张鹏飞. 滑溜牵伸纺纱对羊毛/山羊绒混纺纱性能的影响[J]. 毛纺科技, 2017,45(7):9-12.
CHENG Haonan, JIANG Liping, ZHANG Pengfei. Affect of wool/cashmere blended yarn based on slippery stretch[J]. Wool Textile Journal, 2017,45(7):9-12.
[5] 张先述. 麻棉混纺粗号纱的生产[J]. 棉纺织技术, 2009,37(3):32-34.
ZHANG Xianshu. Production of ramie cotton blended coarse yarn[J]. Cotton Textile Technology, 2009,37(3):32-34.
[6] 周炳明, 刘雷. 柞绢丝纤维生产及纺纱工艺要点[J]. 纺织导报, 2018(9):39-42.
ZHOU Bingming, LIU Lei. Production of tussah spun silk fiber and related spinning process[J]. China Textile Leader, 2018(9):39-42.
[7] 桂亚夫. 纺特色纱用牵伸器材及其技术探讨[J]. 纺织器材, 2013,40(6):40-41, 68.
GUI Yafu. Discussion on drafting equipment and technology for spinning special yarn[J]. Textile Accessories, 2013,40(6):40-41, 68.
[8] 史晶晶, 杨恩龙, 陈伟雄, 等. 段彩纱纺纱技术浅析[J]. 棉纺织技术, 2013,41(4):66-68.
SHI Jingjing, YANG Enlong, CHEN Weixiong, et al. Analysis of segment-color yarn spinning technology[J]. Cotton Textile Technology, 2013,41(4):66-68.
[9] 罗建红, 姚凌燕. 纺纱技术[M]. 上海: 东华大学出版社, 2015: 146-155.
LUO Jianhong, YAO Lingyan. Spinning technology[M]. Shanghai: Donghua University Press, 2015: 146-155.
[10] 郁崇文. 纺纱学[M]. 北京: 中国纺织出版社, 2009: 131-142.
YU Chongwen. Spinning[M]. Beijing: China Textile & Apparel Press, 2009: 131-142.
[11] 李瑛慧, 谢春萍, 刘新金. 基于纤维变速点分布实验的成纱条干不匀研究[J]. 纺织学报, 2016,37(8):32-36, 58.
LI Yinghui, XIE Chunping, LUI Xinjin. Study on yarn unevenness based on experiment of fibers accelerated-point distribution[J]. Journal of Textile Research, 2016,37(8):32-36, 58.
[1] CHENG Yue, AN Qi, LI Dawei, FU Yijun, ZHANG Wei, ZHANG Yu. Preparation of SiO2 in-situ doped polyvinylidene fluoride nanofiber membrane and its properties [J]. Journal of Textile Research, 2021, 42(03): 71-76.
[2] ZHANG Yike, JIA Fan, GUI Cheng, JIN Rui, LI Rong. Preparation and piezoelectric properties of carbon nanotubes/polyvinylidene fluoride nanofiber membrane [J]. Journal of Textile Research, 2021, 42(03): 44-49.
[3] XING Yusheng, HU Yi, CHENG Zhongling. Preparation and properties of Si/TiO2 composite carbon nanofibers [J]. Journal of Textile Research, 2021, 42(03): 36-43.
[4] WANG Huiyun, WANG Ping, LI Yuanyuan, ZHANG Yan. Preparation of polyacrylonitrile hollow porous shaped fibers and its performance [J]. Journal of Textile Research, 2021, 42(03): 50-55.
[5] SHI Qianqian, WANG Jiang, ZHANG Yuze, LIN Huiting, WANG Jun. Numerical analysis on formation mechanism of airflow field in rotor spinning unit [J]. Journal of Textile Research, 2021, 42(02): 180-184.
[6] YIN Shiyong, BAO Jinsong, TANG Shixi, YANG Yun. Modeling method of cyber physical production system for ring spinning [J]. Journal of Textile Research, 2021, 42(02): 65-73.
[7] LI Hao, XING Mingjie, SUN Zhihao, WU Yao. Exploration of image-based testing method for yarn twist in air-jet vortex spinning [J]. Journal of Textile Research, 2021, 42(02): 60-64.
[8] ZHENG Sensen, GUO Tao, DONG Jie, WANG Shihua, ZHANG Qinghua. Preparation, structure and properties of high-strength high-modulus polyimide fibers containing benzimidazole moiety [J]. Journal of Textile Research, 2021, 42(02): 7-11.
[9] GUO Xuesong, GU Jiayi, HU Jianchen, WEI Zhenzhen, ZHAO Yan. Preparation and properties of polyacrylonitrile/carboxyl styrene butadiene latex composite nanofibrous membranes [J]. Journal of Textile Research, 2021, 42(02): 34-40.
[10] WANG Ying, WANG Yiting, WU Jiaqing, GUO Yafei, HAO Xinmin. Preparation of compound antistatic spinning oil for bio-based polyamide 56 and its effect on staple fiber spinnability [J]. Journal of Textile Research, 2021, 42(01): 84-89.
[11] CHEN Yunbo, ZHU Xiangyu, LI Xiang, YU Hong, LI Weidong, XU Hong, SUI Xiaofeng. Recent advance in preparation of thermo-regulating textiles based on phase change materials [J]. Journal of Textile Research, 2021, 42(01): 167-174.
[12] LIAO He, WANG Jianning, ZHANG Dongjian, GAN Xuehui, ZHANG Yumei, WANG Huaping. Numerical simulation of interface distribution of side-by-side bi-component melt in orifice [J]. Journal of Textile Research, 2021, 42(01): 30-34.
[13] WANG He, WANG Hongjie, RUAN Fangtao, FENG Quan. Preparation and properties of carbon nanofiber electrode made from electrospun polyacrylonitrile/linear phenolic resin [J]. Journal of Textile Research, 2021, 42(01): 22-29.
[14] YANG Gang, LI Haidi, QIAO Yansha, LI Yan, WANG Lu, HE Hongbing. Preparation and characterization of polylactic acid-caprolactone/fibrinogen nanofiber based hernia mesh [J]. Journal of Textile Research, 2021, 42(01): 40-45.
[15] CHEN Meiyu, LIU Yulin, HU Geming, SUN Runjun. Effect of wrapping and twisting on mechanical properties of air-jet vortex spun yarns [J]. Journal of Textile Research, 2021, 42(01): 59-66.
Viewed
Full text


Abstract

Cited
  Shared   
  Discussed   
No Suggested Reading articles found!
京ICP备14006648号
Copyright 2021 © Editorial office of Journal of Textile Research
Supported by Beijing Magtech Co.Ltd