Journal of Textile Research ›› 2020, Vol. 41 ›› Issue (01): 139-144.doi: 10.13475/j.fzxb.20181105406

• Apparel Engineering • Previous Articles     Next Articles

Free convection calculation method for performance prediction of thermal protective clothing in an unsteady thermal state

DING Ning1, LIN Jie2()   

  1. 1. College of Aeronautical Engineering, Civil Aviation University of China, Tianjin 300300, China
    2. Sino-European Institute of Aviation Engineering, Civil Aviation University of China, Tianjin 300300, China
  • Received:2018-11-20 Revised:2019-09-25 Online:2020-01-15 Published:2020-01-14
  • Contact: LIN Jie E-mail:linj022@126.com

Abstract:

A method for the surface heat transfer coefficient calculation of free convection is proposed, which plays an important part in the numerical heat insulation prediction of thermal protective clothing under unsteady thermal state in high temperature environments, where heat transferred by free convection cannot be ignored or even is the main part. A typical heat transfer model was presented under an unsteady thermal state, using finite difference method. Two sets of numerical results were obtained under two boundary conditions at the outer surface of clothing, these conditions being constant temperature boundary condition and Howard model's free convection boundary condition. However, the comparison between experimental and the two numerical analysis results showed obvious differences. For improvement, a method using Fourier's law, Newton cooling law and free convection condition of Howard model was proposed under linear assumption to calculate free convection heat transfer coefficient. Improving the heat transfer model with this method, three sets of numerical results were obtained using finite difference method with different time steps, and the comparison between experimental and these three numerical results showed fast convergence to experimental results with time step getting smaller. The difference between the calculated and experimental results was less than 0.1 ℃ when time step was set to 0.001 s.

Key words: thermal protective clothing, thermal insulation, heat transfer, free convection, numerical simulation

CLC Number: 

  • O242.1

Fig.1

Schematic of heat transmission"

Tab.1

Thermophysical/geometrical properties of different material"

材料
编号
密度/
(kg·m-3)
比热/
(J·(kg·℃)-1)
热传导率/
(W·(m·℃)-1)
厚度/
mm
材料1 300 1 377 0.082 0.6
材料2 862 2 100 0.370 6.0
材料3 74.2 1 726 0.045 3.6
材料4 1.18 1 005 0.028 5.0

Fig.2

Numerical results with different boundary conditios (a) and time step (b)"

Fig.3

Difference between results calculated and experiment with Δt=0.001 s"

Fig.4

Heat flux density at different time with Δt=0.001 s"

[1] 田苗, 李俊. 数值模拟在热防护服装性能测评中的应用[J]. 纺织学报, 2015,36(1):158-164.
TIAN Miao, LI Jun. Application of numerical simulation on performance evaluation of thermal protective clothing[J]. Journal of Textile Research, 2015,36(1):158-164.
[2] TORVI D A. Heat transfer in thin fibrous materials under high heat flux conditions[D]. Edmonton: University of Alberta, 1997:47-48.
[3] 卢琳珍, 徐定华, 徐映红. 应用三层热防护服热传递改进模型的皮肤烧伤度预测[J]. 纺织学报, 2018(1):111-118.
LU Linzhen, XU Dinghua, XU Yinghong. Prediction of skin injury degree based on modified model of heat transfer in three-layered thermal protective clothing[J]. Journal of Textile Research, 2018,39(1):111-118.
[4] CHITRPHIROMSRI P, KUZNETSOV A V. Modeling heat and moisture transport in firefighter protective clothing during flash fire exposure[J]. Heat & Mass Transfer, 2005,41(3):206-215.
[5] TORVI D A, DALE J D. Heat transfer in thin fibrous materials under high heat flux[J]. Fire Technology, 1999,35(3):210-231.
doi: 10.1023/A:1015484426361
[6] MELL W E, LAWSON J R. A heat transfer model for firefighters' protective clothing[J]. Fire Technology, 2000,36(1):39-68.
doi: 10.1023/A:1015429820426
[7] KIM M C, YOON D Y, CHOI C K. Buoyancy-driven convection in a horizontal fluid layer under uniform volumetric heat sources[J]. Korean Journal of Chemical Engineering, 1996,13(2):165-171.
doi: 10.1007/BF02705904
[8] SU Yun, LI Rui, SONG Guowen, et al. Modeling steam heat transfer in thermal protective clothing under hot steam exposure[J]. International Journal of Heat & Mass Transfer, 2018,120:818-829.
[9] 陈扬, 杨允出, 刘莹. 非稳态条件下织物热传递模拟分析[J]. 毛纺科技, 2018,46(8):6-10.
CHEN Yang, YANG Yunchu, LIU Ying. Simulation analysis of heat transfer of fabrics in unsteady-state conditions[J]. Wool Textile Journal, 2018,46(8):6-10.
[10] PIOTR Furmański, PIOTR Łapka. Evaluation of a human skin surface temperature for the protective clothing-skin system based on the protective clothing-skin imitating material results[J]. International Journal of Heat & Mass Transfer, 2017,114:1331-1340.
[11] 张昭华, 王云仪, 李俊. 衣下空气层厚度对着装人体热传递的影响[J]. 纺织学报, 2010,31(12):103-107.
ZHANG Zhaohua, WANG Yunyi, LI Jun. Effect of thickness of air layer under clothing on heat transmission of wearer[J]. Journal of Textile Research, 2010,31(12):103-107.
[12] MIN K, SON Y, KIM C, et al. Heat and moisture transfer from skin to environment through fabrics: a mathematical model[J]. International Journal of Heat & Mass Transfer, 2007,50(25):5292-5304.
[13] 中国工业与应用数学学会. 高温作业专用服装设计[EB/OL]. [2018-9-13]. [EB/OL]. [2018-9-13]. .
[1] SHI Qianqian, WANG Jiang, ZHANG Yuze, LIN Huiting, WANG Jun. Numerical analysis on formation mechanism of airflow field in rotor spinning unit [J]. Journal of Textile Research, 2021, 42(02): 180-184.
[2] WANG Qi, TIAN Miao, SU Yun, LI Jun, YU Mengfan, XU Xiao. Effect of open/closed air layer on thermal protective performance of flame-resistant fabrics [J]. Journal of Textile Research, 2020, 41(12): 54-58.
[3] MENG Jing, GAO Shan, LU Yehu. Investigation on factors influencing thermal protection of composite flame retardant fabrics treated by graphene aerogel [J]. Journal of Textile Research, 2020, 41(11): 116-121.
[4] YING Lili, LI Changlong, WANG Zongqian, WANG Dengfeng, WU Kaiming, XIE Wei, CHENG Huan. Modification of down by zirconium ion with phytic acid and its thermal insulation performance [J]. Journal of Textile Research, 2020, 41(10): 94-100.
[5] ZHAI Li'na, LI Jun, YANG Yunchu. Development and current state of thermal sensors used for testing thermal protective clothing [J]. Journal of Textile Research, 2020, 41(10): 188-196.
[6] CHU Xi, QIU Hua. Flow simulations of ring swirl nozzle under different inlet pressure conditions [J]. Journal of Textile Research, 2020, 41(09): 33-38.
[7] ZHANG Lingyun, QIAN Xiaoming, ZOU Chi, ZOU Zhiwei. Preparation and properties of SiO2 aerogel/polyester-polyethylene bicomponent fiber composite thermal insulation materials [J]. Journal of Textile Research, 2020, 41(08): 22-26.
[8] HE Jiazhen, XUE Xiaoyu, WANG Min, LI Jun. Predicting thermal protective performance of clothing based on maximum attenuation factor model [J]. Journal of Textile Research, 2020, 41(06): 112-117.
[9] SU Wenzhen, LU Yehu, WANG Fangming, SONG Wenfang. Development of novel air inflatable jacket and thermal insulating property evaluation [J]. Journal of Textile Research, 2020, 41(05): 140-145.
[10] XIAO Ping, ZHANG Zhaohua, ZHOU Ying, LIU Jiakai, TANG Haoyuan. Influence of arm angular motion on clothing local thermal insulation [J]. Journal of Textile Research, 2020, 41(02): 109-114.
[11] SU Wenzhen, SONG Wenfang, LU Yehu, YANG Xiuyue. Thermal insulation of air inflatable cold protective clothing [J]. Journal of Textile Research, 2020, 41(02): 115-118.
[12] LI Sihu, SHEN Min, BAI Cong, CHEN Liang. Influence of structure parameter of auxiliary nozzle in air-jet loom on characteristics of flow field [J]. Journal of Textile Research, 2019, 40(11): 161-167.
[13] CHEN Si, LU Yehu. Influence of air gap size on steam protective performance of fireproof fabric [J]. Journal of Textile Research, 2019, 40(10): 141-146.
[14] ZHANG Hongyue, LI Xiaohui. Evaluation on radiation thermal performance of honeycomb sandwich structure of thermal protective clothing fabrics [J]. Journal of Textile Research, 2019, 40(10): 147-151.
[15] CHEN Xu, WU Bingyang, FAN Ying, YANG Musheng. Numerical simulation of low temperature protection process for heat storage fabrics [J]. Journal of Textile Research, 2019, 40(07): 163-168.
Viewed
Full text


Abstract

Cited

  Shared   
  Discussed   
No Suggested Reading articles found!